Older furnaces that operate on natural gas are equipped with a pilot light, while most modern gas furnaces use electrical ignition.
If you have an older furnace, you likely have a burning pilot flame that starts your heating system. The pilot light is a little blue flame that ignites the natural gas pushed into the main burner. Occasionally, pilot lights go out, which isn’t a cause for alarm.
However, if your pilot light won’t relight or keeps going out, it could mean that something is wrong with it. As a homeowner, knowing how to relight your pilot light is an essential skill to possess. It’s not difficult, and your furnace may even have instructions to help you. However, it is best to leave furnace repair or furnace service in Garden Grove, CA, to the specialists.
Steps to Relight A Pilot Light.
Before you begin troubleshooting any furnace problem, read over your owner’s manual. Although much general troubleshooting advice is available online, it is always preferable to refer to the recommendations and directions specific to your furnace model.
Locate The Pilot Light Assembly.
After following the instructions, you should be able to locate the pilot light. It’s a small knob towards the bottom of the machine with three indicators: pilot, off, and on. After you’ve located this switch, make sure it’s turned off and wait at least five minutes. That is vital to allow the gas in the system to disperse and help you avoid starting a fire.
During this time, find the reset button, which should be near the off switch, as we will need it later. Typically, the reset button is situated near the pilot switch. If you’re having difficulties finding it, consult your owner’s manual.
Relighting the Pilot Light.
After you’ve waited the required amount of time, you can safely try to relight the pilot light. First, turn the switch to the pilot, then hold down the reset button while presenting a flame to the pilot light enclosure using a long lighter. The furnace pilot light should illuminate immediately, and once you’re sure it’s lit, release the reset button.
If it doesn’t, start anew and try again. Remember to wait roughly two minutes before switching it from the off position to the on position and attempting to relight the pilot. Before each attempt, the excess gas must completely disperse.
Inspect The Furnace And Pilot Light.
Finally, take a few minutes to inspect the furnace and ensure that everything is in working order. Turn on the heater at the circuit breaker and then switch on the heat at the thermostat to test the pilot light. Wait until your furnace comes on, then check if the pilot light is still burning. If your pilot light keeps going out, make an appointment for furnace repair in Riverside, CA.
Contact Professionals For Help.
If you fail to relight your furnace’s pilot light or are uncomfortable executing the actions outlined above on your own, contact Absolute Airflow Air Conditioning, Heating and Plumbing for help. Our trained professionals can provide expert assistance regarding heater replacement in Westminster, CA.
Westminster, CA